Launch to JIC Fittings

Introduction:

JIC Fitting is a selection of hydraulic fittings that’s produced in accordance to the SAE J514 requirements. The acronym JIC stands for Joint Industry Council. It is likewise known as the JIC 37 degrees flare fitting as it has a 37 degrees flare seating area. These fittings are used on oil hydraulic systems in fields which are many (gas delivery, fuel power program, shipbuilding, mobile hydraulic tools, etc…). A JIC fitting structure has three parts that produce a tubing assembly: installing, flare nut, and sleeve.

Material:

Materials used-to fabricate JIC fittings include stainless as well as carbon steel SS316L.

Sizes:

JIC frame and flare nut are available in outer diameter (“OD) sizes between 1/8″ to one 2”. Sleeve has two specific reading measurements, metric size (mm) and inch outer diameter (“OD). Sleeve size is available from 3mm to 50mm as well as 1/8″ to 2”. Connecting sizes are specified by the corresponding outside diameter of the tubing for the various types of tube ends.

Functioning Pressure:

The standard working stress of the fittings ranges from 1000 to 5000 psi for different sizes and connections. The minimum burst stress is four times the working pressure. The JIC fittings must be able to withstand two times the working strain for alpilean real alpilean real reviews – interior-news.com – – interior-news.com – a period of 1 minute with no leakage or failure.

Please take note that the strain rating of an exact same fitting could vary when it’s connected to distinct equipments.. For example, if a fitting with a minimal working pressure is attached to a pipe, it will result in an overall much lower working strain. In all cases, often consider the lowest pressure as the maximum working pressure of the system.

Just how does a JIC fitting works: For tube connections, the assembly procedure starts from the preparation of the tube. For starters, the nut and sleeve are inserted onto the conclusion of a tube. With the use of a flaring tool, form the conclusion of the tube to thirty seven degrees. Next, firm up the nut by using a spanner till the nut is firm and the sleeve grips onto the tube. If the fittings are bench put together, the gripping measures might be driven by revolving the tube using a pair of scissors as the nut is pulled down. When the tube may not be rotated by hand, the sleeve has gripped onto the tube. Once this happens,, tighten the nut by turning it one full turn. This might vary more or less with different tubing materials, but for general practice, it’s a very good rule to follow.

Configurations of JIC Fitting: Commonly made use of connection types consist of: JIC/BSPP Male Connector, JIC/ NPT Male connector, JIC union, JIC/NPT Swivel Male Connector, JIC/BSPP Swivel Male Connector.

Brand of JIC Fittings:

HS Corporation is a Korean supplier specializing in JIC Fitting. Established in 1980, HS Corporation has more than thirty years of specialised experience in manufacturing fittings.